DP10A Two Post Lift | Forward Lift
Forward Lift Website Background Image

DP10A TWO POST LIFT

description

specifications

accessories

Request More Info

Home > Car Lifts > 2 Post Lifts > DP10A Two Post Lift
  • DP10A Two Post Lift Forward Lift
  • Thread-up-adapter
  • F10 Two Post Spot-Rite™ Arm Features

DP10A Two Post Lift Features:

Low-Profile Design:
The DP10A features low-profile/oversized pads with multiple extensions to raise most vehicles on the road today. Includes four (each) adapter extensions: 3.5" and 5".
Spot-Rite™ 3-Stage Front Arm Design:
The DP10A features offset arms to accommodate vehicles both symmetrically and asymmetrically. This feature allows the technician to position the vehicle doors in front of or behind the column to prevent door damage.

Additional Features:
  • 10,000 lbs. capacity for raising most passenger cars, trucks and vans.
  • Direct-Pull Lifting - high efficiency, low maintenance technology
  • Closed loop hydraulic system - preventing hydraulic contamination
  • Powder coat, oven baked finish - more durable than conventional coatings
  • Third party tested by ETL and certifed by ALI
  • Padded shut-off bar
  • Spring operated arm restraints, disengage at floor level
  • Low profile arms
  • Single point release lock in each column, resets on upstroke
  • Optional high rise and extended height available
  • Door bumpers included

DP10A Spot-Rite™ 3-Stage Front Arm Design vs Standard 3-Stage Front Arms

I10 Spot-Rite™ Arm Design

Spot-Rite™ 3-Stage

  • Preferred Drive-in Arm Position
  • Front arms fold parallel to rear arms for clear vehicle drive-thru space
  • Arms swing to vehicle pick up points without front tire interference
  • Improve technician productivity with easy to spot arms
  • Spotting maneuverability improvment from the same side of column
I10 Spot-Rite™ Arm Design Standard Two Post Lift

Standard 3-Stage Arm Design

  • Restricted Drive-in Arm Position
  • Front arms do not fold parallel to rear arms next to column
  • Arms may interfere with vehicle at certain points.
  • Car must be placed more precisely to clear front tires - may require additional tech time to reposition vehicle.

The DP10A 2-post lift comes standard with offset, three-stage front arms. These arms fold parallel to the rear arms during vehicle drive-in . This allows them to be set in an asymmetric lifting position, behind the front tires during vehicle drive-in. The vehicle's lifting points can be easily and quickly spotted without having to reposition the vehicle back and forth to reach it's manufactur's lift points.



Automotive Lift Institute Logo
Shown: DP10AN400BL
Capacity: 10,000 lbs.

Standard lift colors include blue and red.

 
 
SpecificationsDP10AN400BL
Capacity10,000 lbs. (4535kg)
Rise76-1/4" (1937mm)
Overall Height143" (3632mm)
Overall Width131" or optional 137" (3327mm / 4380mm)
Drive Through Clearance99" or optional 105" (2515mm / 2667mm)
Overhead Switch Height137-5/8" (3496mm)
Front Reach23"- 44-1/2" (584mm - 1130mm)
Rear Reach36"- 58" (914mm - 1473mm)
Min/Max Adapter Height3-3/4" (95mm) no adapter extension
8-3/4" (222mm) w/5" adapter extension
Width Inside Column109" or optional 115" (2769mm / 2921mm)
Voltage208/230, 15 amps; 208/230, 16 amps
Motor1hp*/2hp/50Hz; 1hp*/2hp/60Hz
Ceiling Height Required144" (3658mm)

*3-phase available at additional cost. Lifts are available in blue and red.

Specifications subject to change without notice or liability.

Two Post Accessories


 

Two Post Lift Accessories

 

Air / Electric Utility Box

Part # 991359

 
 

 



Forward Lift®

News Room

Phone:

  • Toll Free:
    800-423-1722
  • 812-273-7325

© Vehicle Service Group, All Rights Reserved. Unless otherwise indicated, Forward Lift® and all other trademarks are property of Dover Corporation and its affiliates.